Sub-Zero Classic BI Code 35-A-37: Air filter fan shorted

What 35-A-37 means

Sub-Zero lists 35-A-37 on Classic built-ins like the BI-36UFD/S for an air filter fan pulling too much current. The control reads that as a shorted air filter fan. A short can come from a seized motor, damaged windings or moisture in the fan, and the board shuts the fan down to protect itself. Expect the air purification to stop and, in some cases, a faint electrical smell near the filter housing, while cooling continues.

Common causes of 35-A-37

Shorted air filter fan motor
Seized fan forcing high current draw
Moisture or debris at the fan connector

✓ One safe check you can try

1. If you notice a burnt smell from the filter area, turn off the breaker and call us. 2. Without a smell, leave the unit running and keep doors closed as much as possible. 3. Check for water drips near the filter housing and wipe them dry. 4. Do not attempt to remove the housing to reach the fan.

! Why to stop there

A shorted motor can stress the board output that powers it.
We verify the short before replacing the fan so the board is not damaged again.
The fan housing is part of the interior panels and clips.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Refrigerator codes

deSub-Zero 600 and 700 Series Display de: Diagnostics enabled 23Sub-Zero 600, 700 and 648PRO Code 23: Defrost overheat with no feedback 50Sub-Zero 600 and 700 Series Code 50: Refrigerator compressor running too long 41Sub-Zero 648PRO Code 41: Zone compressor or wiring problem 81Sub-Zero 700-2 Code 81: Variable-Speed compressor fails to start 82Sub-Zero 700-2 Code 82: VS compressor controller needs replacement 88Sub-Zero 700TF Code 88: Board and compressor controller not talking 80Sub-Zero 700TF Code 80: No inverter feedback after a board change

35-A-3735-A-37 questions

Why is a high-current fan treated as urgent?

High current means the fan is shorted or seized. The board output feeding it can be damaged if the fan keeps getting power, so the control stops it and logs 35-A-37 instead.

Can the board be damaged already?

Usually the control protects itself, but we still test the fan output after replacing the motor. If the output is weak, we explain the options before doing anything more.

How is this repaired?

We replace the air filter fan and check the wiring and board output. You approve a written price before work starts, and the job has a 30-day workmanship warranty.