Sub-Zero Classic BI Code 60-2-60: Freezer compressor draws no current

What 60-2-60 means

When a Classic Built-In such as the BI-36U/S or BI-36UFD/S displays 60-2-60, the control has tried to run the freezer compressor and found no load on that circuit. Nothing drew current after the board switched it on, so as far as the control can tell the freezer compressor is not connected. Owners typically see the freezer temperature rising, ice cubes beginning to melt or clump, and silence from the machine compartment where the compressor would normally run.

Common causes of 60-2-60

Unplugged, loose or heat-damaged connector on the freezer compressor circuit
Freezer compressor drive that is not passing power
Open winding or tripped internal overload in the freezer compressor
Main board output that fails to energize the circuit

✓ One safe check you can try

1. Write down 60-2-60 and when you first saw it. 2. Reset power at the breaker: off for two minutes, then on. 3. Listen at the toe grille for the freezer compressor over the next ten minutes. 4. Keep the freezer door shut; a full freezer stays cold longer. 5. Call us if the compressor stays silent.

! Why to stop there

Tracing an open circuit means working beside live line voltage.
An open winding is sealed-system work that requires certified refrigerant handling.
Classic BI wiring layouts vary by series, and mistakes can damage the drive.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Refrigerator codes

23Sub-Zero 600, 700 and 648PRO Code 23: Defrost overheat with no feedback 50Sub-Zero 600 and 700 Series Code 50: Refrigerator compressor running too long 41Sub-Zero 648PRO Code 41: Zone compressor or wiring problem 81Sub-Zero 700-2 Code 81: Variable-Speed compressor fails to start 82Sub-Zero 700-2 Code 82: VS compressor controller needs replacement 88Sub-Zero 700TF Code 88: Board and compressor controller not talking 80Sub-Zero 700TF Code 80: No inverter feedback after a board change ddSub-Zero 600 and 700 Series Display dd: Diagnostics switched off

60-2-6060-2-60 questions

My freezer compressor is silent. Is that what 60-2-60 means?

Yes, that matches. The control powered the freezer compressor circuit and detected no current draw. The cause can be as simple as a loose connector or as serious as an open winding, which is why we test before quoting.

Is it safe to keep using the refrigerator side?

On these models the fresh-food side cools on its own system, so it usually keeps working. Just keep an eye on its temperature and avoid stuffing it with frozen items, which can overload it.

Will you replace the compressor right away?

Only if testing shows it is needed. We first check the wiring, connectors and drive, then give you a written price. If a sealed-system repair is required, we explain the options before any work starts.