Sub-Zero DET3650CI 36-inch over-and-under with ice maker repair
The DET3650CI is a 36-inch Designer model with the refrigerator on top, the freezer below, and an ice maker, sharing its platform with the DET3650C. It is panel ready and typically installed in a wide opening, where its custom front is meant to match the kitchen.
Longer compressor run time is something we measure rather than guess at. We time the cycles, clean the grille, test the fans, and look at the gasket. If the display disagrees with a separate thermometer, the sensor is tested only after the seal and airflow are cleared.
The ice maker goes through its own review of the fill tube, the filter, and the mold. Our estimate covers labor and parts together, so there are no surprises at the end of the visit. Any work we perform comes with a 30-day workmanship warranty.
There is no single number, since it depends on kitchen heat and door use. If it runs most of the day, airflow or sealing needs attention, and we diagnose before quoting.
Possibly, but we rule out a leaky gasket and poor airflow first. A separate thermometer tells us what the cabinet is doing. We stay until the unit is holding its temperature.
Low water pressure, an old filter, or a cold fill tube are common reasons. We check them first, and our work includes a 30-day workmanship warranty.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
